Assembly Step 2: Enclosure assembly

Assembly Instructions

Mount the assembled PCB onto the acrylic enclosure base

Mount the assembled PCB onto the four short (1/4”) round standoffs using the four smaller (3/16”) screws and mount the PCB onto the clear acrylic base with four of the 1/4” screws.

_images/image_15.JPG

Place the four longer (1”) round standoffs in each corner

The standofs are used to secure the top and the enclosure.

_images/image_15b.JPG

Place the four sides onto the clear base

_images/image_17.JPG

Place the top onto the case and secure with the remaining four 1/4” screws

_images/image_18.JPG

Mount the knob onto the flat side of the potentiometer

This style of knob uses a set screw for mounting onto the potentiometer. Place the knob onto the potentiometer so that the set screw is on the same side as the flat-side of the potentiometer. Use the mini-screwdriver blade to tighten the set screw down as shown in the images below.

_images/knob_1_2.png

Image of the final assembled device

_images/knob_3.png