Stir Plate Kit

Assembly of the Colorimeter Stir Plate enclosure

«  Step 6: Using the stir plate   ::   Contents

Assembly of the Colorimeter Stir Plate enclosure

Most of the build steps are the same as the previous desktop instructions. The main difference is in the positioning of the motor and PCB within the enclosure. Images below highlight these differences and where the parts should be placed.

Connecting motor to the PCB

Mount the PCB and motor/magnet hub (assembled as described earlier) onto the base plate as shown in the images below. Connect the wires from the motor to the PCB.

_images/colorimeter_step1a.png
_images/colorimeter_step1b.png

Connecting power to the PCB

Mount the power (assembled as described earlier) onto the base plate as shown in the images below. Connect the wires from the power jack to the PCB.

_images/colorimeter_step2a.png
_images/colorimeter_step2b.png

Enclosure sides and standoffs

Mount the 4 enclosure standoffs in each corner and place the remainder of the enclosure sides onto the base.

_images/colorimeter_step3.png

Enclosure top

Place the top plate and screw in place with the flat-headed screws.

_images/colorimeter_step4.png

Final step - colorimeter holder

Finally, place the 1/4” thick acrylic colorimeter holder onto the top and scew in place.

_images/colorimeter_step5a.png
_images/colorimeter_step5b.png

«  Step 6: Using the stir plate   ::   Contents